User Access Manager Help >> Operation Guide >> User Access Policy >> Portal Service >> Portal IP Address Group >> Add/Modify IP Address Group

Add/Modify IP Address Group

This function helps you add/modify an IP address group.

Operation Procedure

1. Select the User tab, and then in the navigation tree click User Access Policy > Portal Service > IP Group to enter the Portal IP Group page.
2. Click Add or click corresponding to an IP address group in the IP address group list.
3. Enter an IP group name, a start IP address, an end IP address, an action, and so on.
4. Click OK.

Precautions

• The end IP address you set in adding/modifying an IP address group must be greater than or equal to the start IP address.
• If two IP address groups contain same IP addresses, these two IP address groups overlap. For example, IP address group A contains addresses from 192.168.0.1 to 192.168.0.100. IP address group B contains addresses from 192.168.0.100 to 192.168.0.200. IP address group A and IP address group B overlap. Specially, when used for NAT, two IP address groups are considered overlapped only if they contain the same IP address(es) before and after NATed.
• If you add an IP address group without selecting a service group, the default group named Ungrouped is applied.
• When modifying an IP address group, you cannot change the name of the group.
• When you modify an existing IP address group, the associated service group cannot be modified.