Rooms and Walls
Perform this task to draw walls, bulkheads, and room separators. You can use walls and bulkheads to draw rooms in different shapes. Walls are thicker than bulkheads by default. By using room separators, you can divide a room into different areas. In each area, you can use different decorations. Both walls and bulkheads are visible in 3D scenarios. Room separators are invisible in 3D scenarios.
Operation Procedure
- Click the Draw tab.
- From the left navigation tree, click Rooms & Walls. Submenus Wall, Bulkhead, and Room separator (invisible) appear.
Functions
- Draw walls, bulkheads, and room separators: Select Wall, Bulkhead, or Room separator (invisible), and click the mouse at the start point. Move the pointer to the end point and click again to finish the drawing. Repeat the same operation to draw another wall, bulkhead, or room separator. When you finish the whole drawing, right-click the mouse. To change the angle between two walls, move the pointer over their joint point. The joint point displays as a green circle. Drag the green circle to change the angle between the two walls. If walls form an enclosed area, a room label appears in the center of the area. Click the label, and the Settings dialogue box appears. Set the room name, wall thickness, and elevation, select whether to display the roof, and then click OK.
- Delete a wall, bulkhead, and room separator: Click the wall, bulkhead, or room separator you want to delete, and then click Remove. You cannot delete the last wall of the equipment room.
- Set parameters for a wall, bulkhead, and room separator: Click the wall, bulkhead, or room separator, set parameters in the Settings dialogue box, and click OK.
Related Topics